SEMA is the United Nations conference of all things aftermarket, and here’s some of the best stuff we spotted there.
1.Quintin Brothers Dodge Challenger
This 1000-hp Dodge Challenger went on a wild adventure after it arrived in Las Vegas. Vermont-based Quintin Brothers Auto & Performance had their truck and trailer stolen days before the show. Their custom Challenger was inside. Video surveillance helped track down the perp, but when Nevada state trooper Adam Whitmarsh tried to block the stolen Challenger into a parking space, the suspect rammed the Trooper’s Ford Explorer and escaped. After exiting the parking structure, the suspect smashed through a fence and drove the stolen Challenger across a nearby karting track—during a karting event. He eventually ditched the car and was later arrested. The Quintin Brothers and their Dodge Challenger arrived at the SEMA show wearing battle wounds from the wild chase.
2. Chevrolet E-10 Concept
It’s not an engine, it’s a motor. The Chevrolet E-10 concept is a 450-hp electrified C-10 pickup. Typically the only time a 1970s Chevy pickup is plugged into anything, it’s connected to a trickle charger. The E-10 has its batteries in the bed. The two electric motors seen here are called eCrate motors, a nod to the popular Chevy crate engines that can be found swapped into just about anything. GM claims the E-10 can complete a zero-to-60-mph run in about five seconds with a quarter-mile time in the high 13s. A Tesla P100D might be quicker, but it doesn’t look as cool.
3. Vibrant Performance Titanium Chair
Had Game of Thrones producers used Nissan Skylines or Toyota Supras instead of dragons as source material, this might be the Iron Throne. Vibrant Performance didn’t have to vanquish their enemies to build the thing, but they did use more than 50 pieces from their lineup of titanium exhaust products to construct what’s likely the most uncomfortable Adirondack chair on the porch. But it’s fun. Feeling exhausted? Have a seat.
4. Hyundai Veloster Grappler Concept
You’re unlikely to see a Hyundai Veloster on an off-road trail, let alone a dirt road, but this overland concept is out to change that. The Veloster Grappler concept is equipped with typical in-car camping accessories like a rear-hatch tent, solar panels, LED light bars, big all-terrain tires, and a roof basket to carry a spare. It’s still pretty low to the ground, and the tire clearance isn’t ideal for crawling, but it’s a concept. We’d pitch a tent with this thing.
5. Toyota Supra Wasabi Concept
Toyota’s Genuine Accessory Team cooked up a color for this concept that we hope will soon find its way onto a Camry. This Supra’s paint mimics wasabi paste and features white accents on the brake calipers, mirrors, stripes, and spoiler. The forged-aluminum wheels were designed at Toyota and have center caps with the original Toyota emblem. Ohlins coil-overs drop the Supra concept two inches. This was one of many Toyota Supras at the show.
6. AEV Jeep Gladiator
This Jeep Gladiator is equipped with all the proper get-dirty-quick gear. It has tough Bilstein dampers, a lifted suspension, and 37-inch tires. American Expedition Vehicles (AEV) is known for swapping big engines into off-road vehicles and then adding lift kits and other off-road accessories. They’re also responsible for the coolest parts of the Chevy Colorado ZR2 Bison. This year AEV brought three green machines to show off their latest accessories.
7. 1999 Honda Civic Si Super Street Build
Was this the car that sparked the movie The Fast and the Furious in 2001? It sure looks like it. Honda brought a handful of concepts to the show in celebration of its 60th year in North America, and what better way to do it by showcasing the Civic Si Super Street magazine modified for the Civic Si Challenge in 2000. If you collected buckets of Mattel die-cast cars as a kid (or shamelessly as adults, like us), this car might look familiar.
8. Nissan Frontier Desert Runner
The current-gen Nissan Frontier might be 16 years old, but this concept proves that Nissan knows what people at SEMA want in a truck: tons of suspension, awesome off-road tires, some type of light bar, and a 600-hp 5.8-liter V-8. In the meantime, we can only hope one of these ingredients get put to use on the upcoming Frontier refresh.
9. RTR Rambler Ford Ranger Concept
The RTR Rambler Ford Ranger does everything right without going too far. Ford chose 33-inch Nitto Ridge Grappler tires with custom RTR Tech 6 wheels, because they know anything bigger than that will be unnecessary in most cases. Three LED light bars are tastefully tucked into a custom front grille to complete an almost Ranger Raptor–like appearance. A two-inch suspension lift is installed as well as heavy-duty rock sliders, which act as both a step and as extra protection against rocky terrain. It’s a simple package done well, saving the flashy stuff like wild paint for the Insta-campers.
10. 1972 Honda N600
If it looks like this 1972 Honda N600 has a motorcycle engine under the hood, it’s because it does. This oddball is powered by a Honda VFR 800-cc V-4 motorcycle engine that puts power to the rear wheels. Although the car itself predates the era of high-revving VTECs, with the bike motor installed, this is likely the only N600 with a 12,000-rpm redline. This was one of several cars Honda showcased at the SEMA show.
11. Honda Civic Si Drift Car
This is a peek under the hood of a 926-hp Honda Civic Si. The engine is turned longitudinally and transforms a front-wheel-drive coupe into a rear-wheel-drive drift-spec machine. The work was done with help from Jeanneret Racing and Olson Kustom Works.
12. Chevrolet Silverado ZR2 Prototype
We saw this Chevrolet Silverado Desert race truck back in early October, when it competed in the Laughlin Desert Classic, a 17-mile race event in Nevada near the Arizona border. It was there for “engineering development,” but we still think it’s a preview of an upcoming Silverado Z
13. Honda Rally Passport
Honda R&D in Ohio built this rally-ready Honda Passport in their spare time. It has already survived a handful of rally competitions, finishing second in its class at the Southern Ohio Forest Rally. It has had typical safety additions like a roll cage, but other than that it’s unchanged except for tires, brake pads, wheels, and skid plates. Oh, there’s also the addition of a hand-operated hydraulic brake, for epic drift action.
14. 1968 Ford Bronco
There’s been plenty of buzz lately about the upcoming Ford Bronco, which is expected to debut in early 2020. A collaboration between Jay Leno and Ford, this Bronco has a supercharged 5.2-liter V-8 from the Ford Mustang Shelby GT500 and a five-speed manual transmission. The restoration maintained the simple beauty of original Bronco. The 18-inch steel wheels by Detroit Steel Wheels are a great combination of old style and modern needs. The Bronco’s Tonight Blue color would look great on a Mustang or F-150 Raptor.
15. Hyundai Veloster N Performance Concept
The Veloster N is quick, but this Veloster N Performance concept is quicker. Hyundai modified its hot hatch with carbon fiber for the front splitter, side skirts, rear diffuser, and spoiler while adding carbon fiber to each wheel’s center caps. The suspension is made up of Extreme Racing coil-overs and H&R coil springs with aluminum chassis bracing to add rigidity. Orange-accented interior bits stand out among more carbon-fiber pieces and an Alcantara dashboard.
16. SpeedKore Dodge Charger
Routed through the front fender of a 2019 Dodge Charger Pursuit is the exhaust from a 1525-hp Dodge Demon V-8. This project, put together by SpeedKore Performance Group and MagnaFlow, began as a police car. After fitting a carbon-fiber widebody kit, they turned it into something that would outrun police cars. The stock supercharged 6.2-liter V-8 was transformed into a twin-turbo engine and received an upgraded upper intake manifold designed to withstand the 26 psi of boost.
Written by: Austin Irwin, Car&Driver
Plus a set of step-by-step instructions from the maker himself.
The 2020 Corvette C8 is probably one of the most popular cars this year. Its performance figures matched with an affordable price tag warrant the attention that it has been getting since its reveal. The problem is, those who would like to get their hands on one will have to wait until next year since Chevrolet will commence deliveries in 2020.
If patience isn’t your strongest suit, well, there’s this – 1:20 scale of the Corvette C8 made out of Lego bricks. This isn’t made out of pre-fabricated brick, though. This Lego build by Lasse Deleuran isn’t an official Corvette C8 set but with regular bricks, rather.
Read full story at deBotech